Hyundai Palisade Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
For folks who has it, how wide is Palisade including side mirrors? We have a rather small garage door so trying to figure out if it would fit. Bummer that the side mirrors are not power-folding.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #4
Well, actually according to Hyundai's spec here, the width of 77.8 inch is without mirrors. It's probably another 10 inches more with mirrors which means it likely won't fit :cry:
 

·
Registered
Joined
·
259 Posts
I stand corrected. Thank you Geqiang. My eyeball measurement needs calibration, so I went back out and did an physical measurement from the outside of the drivers mirror thru the Palisade to the passenger window's outside and that measurement was 91" Hope this helps with your decision making.
 

·
Super Moderator
Joined
·
418 Posts
Need switch to operate, where do you locate it? need wiring to mirror and power, then you could worry about
Which Genesis mirror might fit. That would be the only way you could find a Hyundai based mirror.
You then would have to have it painted to match your vehicle as Genesis paint doesn't have to match Hyundai paints.
 

·
Registered
Joined
·
4 Posts
Discussion Starter #8
I stand corrected. Thank you Geqiang. My eyeball measurement needs calibration, so I went back out and did an physical measurement from the outside of the drivers mirror thru the Palisade to the passenger window's outside and that measurement was 91" Hope this helps with your decision making.
Thanks again Sterling!
 

·
Registered
Joined
·
33 Posts
The question should be asked of Hyundai if the existing wiring harness is capable of fold and dimming commands in preparation for later model year addition. If the answer is yes, a modification kit sold to requesting Palisade owners, even at a several hundred dollar cost, would likely go far in ameliorating the current annoyance fell by those owners at being slighted of those safety features on a fifty grand vehicle. If the answer is no, add wiring to the refit option and get on with it.
 
1 - 9 of 9 Posts
Top