Hyundai Palisade Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
252 Posts
At a quick glance, these appear to be casting defects which is quite common on casting components that see only low stress, are non-critical, and need to be low cost. I imagine the QA would be fairly minimal where some would be removed for non-invasive radiography.

I agree that aesthetically, it doesn’t look the best but it should meet expected life cycle.
 

·
Registered
Joined
·
252 Posts
Larry and Ralph, I believe the area both of you are referring to is part of the casting and not a fastener. I agree that it doesn’t look the best visually
 
1 - 2 of 2 Posts
Top